LF 3084 Schedule
FlyNordic operates CGI to DFW Mon Tue Thu Fri Sun. Scheduled block time is 2h. Typically a Canadair Regional Jet 200.
Canadair Regional Jet 200 (CR2)
Scheduled equipment: Canadair Regional Jet 200. Canadair-built. Registration, build year, and photo fill in the moment the aircraft broadcasts.
CGI to DFW
FlyNordic is the only nonstop operator on this route. Compare schedules, codeshares, and on-time performance across every operator on the full route page.
LF 3084 Flight Path
Cruise altitude, ground speed, and vertical rate from ADS-B broadcasts. The altitude profile fills in while LF 3084 is airborne, capturing climbs, step-climbs, and descents in real time.
Flight path chart appears once LF 3084 is airborne and broadcasting.
Frequently Asked Questions
If a plane icon is moving on the map, yes. That's ADS-B, the aircraft's own GPS position broadcast, updated every few seconds. No icon means the flight isn't airborne at the moment: either before pushback, already landed, or a day it doesn't operate.
Scheduled equipment is the CR2. The live tracker shows the actual tail and registration when LF 3084 is airborne. Carriers swap aircraft often enough that you'll sometimes see a different airframe than the scheduled type.
Mon Tue Thu Fri Sun. 5 days a week. On days outside that pattern this page will show the schedule but no live aircraft.
Scheduled 2h 0m gate to gate from CGI to DFW. Actual air time varies with winds and ATC routing. Tailwinds can shave 15 to 20 minutes on long segments.
GPS-accurate via ADS-B. Typically within 30 meters horizontally, updated every 5 to 10 seconds. If the broadcast drops over oceans or mountainous terrain, the map holds the last-known position and the label changes to reflect the signal gap.
A projection from current position, groundspeed, and remaining distance. It doesn't account for descent procedures, holding, or ATC vectoring near the destination. Trust it within plus or minus 10 minutes once the flight is past the halfway mark.